Rinse the tank through with warm water and tip out.
Vax carpet washer not dispensing water.
This is a fairly lengthy and detailed look at the replacement process of the pump responsible for the dispensing of the detergent in a vax carpet cleaner.
In this video i show you how to remove and clean both sets of brushes on a vax dual power pro carpet washer.
Rinse the nozzle under water to remove dirt and debris.
Getting competent advice from the vax chat on troubleshooter was a waste of time.
Does anyone have any ideas about how to fix it peter.
Our vax v 024 carpet washer now refuses to dispense water when the trigger is pulled.
If this does not solve it the answer is most likely that the pipes and valves inside the machine are blocked by congealed shampoo.
Using the handle lift the tank off the machine.
Lift the nozzle release clip and pull the nozzle forward separating the tabs on the nozzle and carpet washer.
Pull the dirty water tank handle forward and lift the filter to remove.
Rinse the filter under the tap to remove any dirt or debris.
Remove both tanks and tilt the carpet washer back.
Vax carpet washer repair.
It was blowing rather than sucking.
Its most useful advice is to take off the dirty water tank turn on the motor and check the hole by the motor to see if it is sucking.
To replace the nozzle line up the tabs on the nozzle with the tabs underneath the front of the carpet washer.
I have dismantled it and found nothing obviously wrong.
Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube.
Our instructional video shows you how to use the vax rapid power revive carpet cleaner.
To cure this put a kettleful of hot water into the water tank and run the machine for a few minutes pressing the trigger on and off to give bursts of pressure to help shift the blockage.
There are a few other alternatives to try.
