For outdoor installation the unit.
Walk in freezer installation guide.
Screed identification and installation there are many styles of screeds used in floorless walk in coolers and freezers.
A minimum of 2 clearance above the walk in is recommended to install the walk in.
General information section 2.
Used for holding fruits vegetables eggs medicine and wood.
On floorless walk ins work panels into pre installed screeding.
Check overhead for anything that could cause a safety hazard electrical wires utility lines air ducting or any other obstructions.
Once panel is inserted correctly install w2 wall panel with w1 panel male edge will be inserted into female edge of w2 panel.
When placing walk in adjacent to building wall s allow 2 minimum clearance on all sides to allow for circulation and to prevent possible condensation on the exterior surface of the walk in.
Locate the screed floor sealer diagram which was packed in the hardware box and using it as a guide draw an outline of the outside dimensions of the installed screed directly onto the building floor where the walk in will be situated.
Make sure the floor arrow on the wall panel is pointing down.
2 walk in cooler freezer application.
Medium temperature walk in freezer.
Installation 3 section 3.
If screed was ordered with your cooler this should be laid out first.
The walk in coolers are walk in freezers are used in a variety of temperature ranges.
First choice to make is whether you need a walk in refrigerator.
Walk in cooler installation steps.
The installer must determine the best and safest way to get the panels to the installation site without damage or bodily injury.
Walk in cooler walk in freezer buying guide walk in refrigerator walk in freezer or combo unit.
The first step is to install the base channel which is attached directly to the floor with concrete anchors.
Indoor or outdoor walk in cooler.
Always have a competent.
Breaker strips thermal breaks are used to prevent heat transfer between the cooled side and the ambient side of a concrete floor.
On floored units place male bottom of wall panel in female groove of floor panel.
High temperature walk in cooler.
Walk ins installed near existing building walls must be positioned with a minimum 2 clearance to allow for air circulation and prevent possible condensation on the exterior surface of the panels.
Do not set a cooler thermostat below the walk ins design temperature or product freezing or excessive evaporator coil icing may result.
Used for holding meats seafood and stuff that needs the same temperature.
Walk in installation operation maintenance warranty manual job name serial number.
The types of screeds furnished with your unit will be identified on the unit assembly drawing.
